This project kinda-sorta got started in November 2013. Before we could decide what we wanted to do, we had to find out what we could do. This is one of the…
Living room floor. Flatten around heater vents
Flatten around heater vents. I created a jig to locate high spots. I would mark the high spots and then use a masonry wheel on my angle grinder to level the…
We ripped the carpet and pad out June 1.
As always, it was NASTY, NASTY, NASTY, under the carpet and pad. It took awhile to clean up
June 3. The initial rows of underlayment and laminate flooring.
June 3. Starting in the NW corner of the room.
June 6. Working across the room.
June 6. Working across the room.
June 7. Made it past the fireplace.
June 7. Made it past the fireplace.
June 8. I finally found the last panel. It was hiding in the bottom of the 18th box of laminate.
June 12. Red oak shoe molding with a coat of Min Wax Provential stain.
June 12. I think this will work as the transition between the tile and the laminate.
June 12. The door from the kitchen to the living room is very slightly wider than a single panel of laminate
June 12. A little glue and patience will fix the issue.
June 12. Another example of poor chraftmanship. The faces of the doorway are not parallel with each other